My new engine was fired up for the first time last night after days of rewiring and replumbing suspect old systems.
At first it would only run with full choke, ran only at high RPM even at idle throttle, and ran rough
I was reaching my arm down to the carb when my arm got sucked onto the manifold Seems I left the bung out of the vacuum port when putting the PCV valve on. It works much better with the port plugged
I'll put up some more photos, but here is a part-finished photo of the fuel and oil filter setup.
At first it would only run with full choke, ran only at high RPM even at idle throttle, and ran rough
I was reaching my arm down to the carb when my arm got sucked onto the manifold Seems I left the bung out of the vacuum port when putting the PCV valve on. It works much better with the port plugged
I'll put up some more photos, but here is a part-finished photo of the fuel and oil filter setup.
Comment