So the engine is out. I tried to remove the head. I tried the wooden shims, PB blaster, heat , tapping with a hammer, still not budging. I'm going to try the welding the nut on the stud next. Unless someone has some other tricks.
Thanks
If you can still turn the engine with the engine with the starter put the plugs back in and see if you can get the compression to break the head loose.
I got the head off. I had to cut one of the bolts off. I cut it off between the head and the block. It was rusted into the head. The others I removed with the welding a nut on the stud trick.
On to the next problem
Just some pictures to remember the fun times of removing my A-4.
I do have a question. I'm cleaning up the engine compartment. I'm getting new vent hoses. the old hoses were very close together in the bottom of the engine compartment. Should I put them back in that position or is there a better placement? I figure the exaust hose should be as low as it can be.
I see you have 2 hoses showing. Are they both extraction or is one an intake? I have only one, mounted as low as possible near the carburetor. I also have louvered vents in the cockpit to introduce fresh air.
I see you have 2 hoses showing. Are they both extraction or is one an intake? I have only one, mounted as low as possible near the carburetor. I also have louvered vents in the cockpit to introduce fresh air.
One is an intake one is extraction. They were placed very close. I was wondering if the extraction hose was just sucking from the intake.
One is an intake one is extraction. They were placed very close. I was wondering if the extraction hose was just sucking from the intake.
That would be a good bet. My experience is that sailboats have no trouble getting air in due to the foiling effect of air running around the dog house and spilling into the companionway. Best to focus on extraction, the lower the better.
So I've finally have my boat ready to launch but with out my Atomic 4 in it. (I have a outboard on now). Im still trying to find a machine shop in the Baltimore Annapolis area. One place told me not to take it anywhere but Moyer Marine. I really don't want to spend $6000.00 for a rebuilt engine if I can freshen mine up. any suggestions?
History of engine
Spent most of its life in lake Erie
Now lives in Annapolis.
Four summers ago it over heated , the impeller broke. It sat for a couple of months but it always turned over. I could never get it started. I finally took it out last fall.
Large extensive Volvo Penta diesel inventory of new and used parts. Auxiliary diesel, saildrive, inboard gears. 3 and 4 liter engines. Also extensive parts for the Universal Atomic Four engines.
They are - or were - the only local place I would trust with an Atomic 4. They do good work, but they are not a bargain basement operation.
This will cost you $2400 and you can do the work from there. my luck with random automotive engine shops was mixed at best. One of them specifically said no more A4 work!
$575.00 sounds much better then $2400.00 but the drive is a little far. Although it might be worth it.
Has anyone gone to Moyer and had them tell you what needs to be done?
Oooops, looks like the page you requested could not be found. Please check the URL for proper spelling and capitalization.
I know NOTHING about any of them except they came up on the following search: antique engine machine shop Annapolis marine
IMHO shops that deal with antique marine engines are far more likely to have a clue about fixing an A4 than a shop that only does cars. YMMV and IMHO.
BTW - did you get the Moyer rebuild manual? That would be money very well spent for this project.
Comment