I am installing a Moor Knotmeter in my Tartan 34 . I would like to swap
out the existing Horizon Transducer over a tide change. This means
that I need to use something that will either cure in under 2 hrs or
continue to cure underwater.
Does anyone have any suggestions? I have spoken to Moor they only
said they do not recommend using anything with polysulfide in it since
the fitting is Lexan.
I have also spoken to 3m marine. They said fast cure 5200 will work, but
needs air to completely cure.
Is there anything anyone has used from the hardware store or plumbing
store that would give me quick seal?
I have some liquid teflon tape that I used on my lawn sprinkler system,
but am reluctant to use it.
Any suggestion appreciated, especially if someone has used it to
seal a thru hull quickly then go underwater it
Thanks very much
Art
out the existing Horizon Transducer over a tide change. This means
that I need to use something that will either cure in under 2 hrs or
continue to cure underwater.
Does anyone have any suggestions? I have spoken to Moor they only
said they do not recommend using anything with polysulfide in it since
the fitting is Lexan.
I have also spoken to 3m marine. They said fast cure 5200 will work, but
needs air to completely cure.
Is there anything anyone has used from the hardware store or plumbing
store that would give me quick seal?
I have some liquid teflon tape that I used on my lawn sprinkler system,
but am reluctant to use it.
Any suggestion appreciated, especially if someone has used it to
seal a thru hull quickly then go underwater it
Thanks very much
Art
Comment