A friend gave me a 1969 Cal 2-30 hull #16 with an engine that needs a bit of attention and a lot of little TLC type bits and pieces, but wow, what a nice boat! I can't wait to launch this spring!!
I'm looking for a tool to cut or grind a new exhaust valve seat on cylinder 2 and cylinder 4. I've searched the forums and there are lots of mentions of tools and cutters or grinders for repairing valve seats, but I didn't find any specifics for the tools being used. I'd like to buy or rent a set of tools for seat repair, but so far I have failed to find the right combination of cutter size and shaft to work on the atomic 4.
Does anyone know where I can buy or rent such a tool? A part number for a tool kit would be super helpful!
Fair winds,
Don
I'm looking for a tool to cut or grind a new exhaust valve seat on cylinder 2 and cylinder 4. I've searched the forums and there are lots of mentions of tools and cutters or grinders for repairing valve seats, but I didn't find any specifics for the tools being used. I'd like to buy or rent a set of tools for seat repair, but so far I have failed to find the right combination of cutter size and shaft to work on the atomic 4.
Does anyone know where I can buy or rent such a tool? A part number for a tool kit would be super helpful!
Fair winds,
Don
Comment