I was so happy my engine fired right up last weekend. This weekend I leaned on the exhaust pipe and the end of the riser broke right off - rusted to pieces
I can make another one from Home Depot black iron, but I am getting the idea that the quality of said iron goes down every time I do this exercise
So besides for the tried, true, and cheap way out, I have:
1. Brass. Seems to violate some USCG/ABYC standard. Nut sure about longevity.
2. Stainless. This will cost a bit more. It might last forever and then again I think someone got 5 years out of stainless before it corroded apart. Any ideas on 304 vs. 316?
I can make another one from Home Depot black iron, but I am getting the idea that the quality of said iron goes down every time I do this exercise
So besides for the tried, true, and cheap way out, I have:
1. Brass. Seems to violate some USCG/ABYC standard. Nut sure about longevity.
2. Stainless. This will cost a bit more. It might last forever and then again I think someone got 5 years out of stainless before it corroded apart. Any ideas on 304 vs. 316?
Comment