Have you driven out the tapered pins?
Rear shaft oil seal replacement
Collapse
X
-
Housing off!
Thanks again Hanleyclifford and the rest of you folks. I got the housing off today thanks to your knowledge and persistent questions and suggestions.
Yes and no about the accessory drive. I had unbolted it but not removed it. Once I did, I saw the pin on that side of the engine and with a quick blow or two it was out - glory be! The screwdriver wedge did the rest, pronto. I am glad that I did not have to drive out the other pin as I would have had to remove the mechanical fuel pump - just one more thing to put back in.
Parts are now all home being cleaned up for inspection and evaluation. I have asked Don, but do any of you know if there are dimensional specs for the clutch plates?
Once again, thank you - how wonderful it is to have such a place to share information and knowledge. Gari------------------------------
Comment
-
-
No answer yet
The last remaining question about whether or not the forward idler bearing had be in place has been answered - yes it was. I also confirmed that the propeller is and has been secure on the prop shaft. The only remaining moving parts would be in the gear case. I will probably need to open that next. Gari------------------
Comment
-
Comment