Hi everyone,
This question is specifically for folks who have installed the EWDS. I purchased mine toward the end of last season apparently just prior to MMI discontinuing it. I installed the pieces over the winter but have a concern with the raw water sensor.
The instructions call for it to be placed before the water pump inlet. When I place it here I get very little to no water flow, to the point that I have concerns with the engine overheating. So I removed it. Has anyone installed it after the water pump and had better success?
Additional info, I changed the impeller on my wayer pump a year ago, and I get plenty of flow when the sensor is not installed. I also verified the flow direction is correct on the sensor itself.
Any other pieces I'm missing?
Thanks!
This question is specifically for folks who have installed the EWDS. I purchased mine toward the end of last season apparently just prior to MMI discontinuing it. I installed the pieces over the winter but have a concern with the raw water sensor.
The instructions call for it to be placed before the water pump inlet. When I place it here I get very little to no water flow, to the point that I have concerns with the engine overheating. So I removed it. Has anyone installed it after the water pump and had better success?
Additional info, I changed the impeller on my wayer pump a year ago, and I get plenty of flow when the sensor is not installed. I also verified the flow direction is correct on the sensor itself.
Any other pieces I'm missing?
Thanks!
Comment