Hello Everyone!
I recently purchased a 1974 Alberg 30 in great condition. The Atomic 4 in the boat is the original engine and runs great. But have an issue lately where a hole has developed in the exaust manifold close to where the flange end. I removed it from the boat and patched the hole with JB weld. It worked for about two weeks and is now leaking exaust again. Does any one here know if maybe the manifold can be repaired by brazing or welding? The rest of the manifold looks to be in very good condition at least on the exterior. I would like to save the manifold if i can.
Any ideas and or advice will be greatly appreciated.
Thanks
I recently purchased a 1974 Alberg 30 in great condition. The Atomic 4 in the boat is the original engine and runs great. But have an issue lately where a hole has developed in the exaust manifold close to where the flange end. I removed it from the boat and patched the hole with JB weld. It worked for about two weeks and is now leaking exaust again. Does any one here know if maybe the manifold can be repaired by brazing or welding? The rest of the manifold looks to be in very good condition at least on the exterior. I would like to save the manifold if i can.
Any ideas and or advice will be greatly appreciated.
Thanks
Comment