Would like to eliminate the warning system as a potential source of intermittent shut down and looking for the preferred way to do disconnect/bypass the system. Which wire(s) do i disconnect/connect etc. Thanks for you help
Bypassing the Temperature/oil pressure warning system
Collapse
X
-
I was composing a post similar to yours Joe but considered the system was connected to the coil + post therefore the possibility exists, however rare, that a problem could affect operation. A short to ground in the alarm system positive attached to the coil could stop the engine. I don't think that is what is happening here but eliminating it as a possibility takes it off the table in troubleshooting.Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Comment
-
Comment