I have a 1972 T30, hull no. 127 with the original A4 with low hours (boat sat for 8 years while owner's estate was settled). This raw water cooled engine has new carb, 55 A alternator, electric fuel pump, electronic ignition, Indigo prop, Racor filter, polishing filter plus a flushing tee which I use to flush out the salt water after each use. Most parts from Moyer, no hassle. Runs super, starts quickly (thanks mostly to the electronic ignition).
Tartans
Collapse
X
-
tartans
Before the installation of the electronic ignition, it would take three or four bursts of the starter, each lasting about 10 seconds, before the A4 would start. I changed points and plugs, checked for choke closure, etc, all not much help.
It was especially hard to start after sitting for a few weeks. I added a switch to short out the oil pressure safety switch which is in series with the electric fuel pump, so that I could run the fuel pump for about 10 seconds if the engine did sit idle for a few weeks. That did seem to help the hard starting after sitting idle for some time.
After installation of the electronic ignition, A4 started on first try and has been doing so consistently. To be fair, I did not change the coil before installing the electronic ignition but did change it after the installation because I was concerned about the higher secondary voltage, so the coil may have been the problem all along. But not having to change points every year was a big plus and electronic ignition is really the way to go.
I love this A4 but do believe in upgrading it with new technology wherever possible.
Comment
-
-
Originally posted by tartansailboat View PostBefore the installation of the electronic ignition, it would take three or four bursts of the starter, each lasting about 10 seconds, before the A4 would start. I changed points and plugs, checked for choke closure, etc, all not much help.
It was especially hard to start after sitting for a few weeks. I added a switch to short out the oil pressure safety switch which is in series with the electric fuel pump, so that I could run the fuel pump for about 10 seconds if the engine did sit idle for a few weeks. That did seem to help the hard starting after sitting idle for some time.
After installation of the electronic ignition, A4 started on first try and has been doing so consistently. To be fair, I did not change the coil before installing the electronic ignition but did change it after the installation because I was concerned about the higher secondary voltage, so the coil may have been the problem all along. But not having to change points every year was a big plus and electronic ignition is really the way to go.
I love this A4 but do believe in upgrading it with new technology wherever possible.
Cost me a new electronic ignition module and 2 weeks at the dock!
Comment
-
-
Tartan 27 Hull ID 69
Original A$ still running strong. SInce this is a new to me boat I do nto have a lot of history. I did replace the alternator and coil this year. She has a bypass system installed, no thermostat, but the rest is all stock (I think) down the the Sherwood water pump, mechanical fuel pump, factory hand pump for oil changes and distributor with the points. She runs great. A littel steam but she raely get over a 160 degree so I taking her as she is.
Tim
Comment
-
-
Thatch: The sump pump I have on the MC, 1965 A-4, is like this http://www.marinedieseldirect.com/ca...ors=&comment1=. Parts 1 thru 15. Not the hand unit # 18. I think they are two different pumps. Mine is mounted on the oil pan between my elec fuel pump and the carb. I can get you a pic but it will be a week or two. Is that the one you are looking for? Dan S/V Marian Claire
Comment
-
-
Neat history lesson!
M.C.
Thank's very much for the oil pump info. No need to send a picture now that I know what I'm looking for. A friend had given me a brass pump which looks a lot like diagram #18 which is probably the portable version of your factory permanent mount unit, #s 1-15. If you use your pump for oil changes, roughly how long does it take to empty your pan.
Tom
Comment
-
-
I do use the pump for oil changes. I would guess 1.5 to 2 minutes total pumping time to remove 3 to 3.5 qts from the pan. I feel as if it has lost some of its uumph over the last few years. I have a short piece of hose with a cap on the end running forward to make filling the empties easier and neater. The unit is removable. Dan S/V Marian Claire
Comment
-
-
"Gunna' give it a try"
M.C.
Since I have a fairly short fixit list scheduled on the boat for tomorrow, I think I'll try that pump that I have. I'll measure the dip stick, warm up the A4 and see how much oil I can suck out. I'll report back.
Tom
Comment
-
Comment