Tonight my flywheel pulley for my FWC came off with the shaft. The shaft (extender?) that it fits on has two set screws that hold it in place. The flywheel shaft has two pins coming out and the extender slides over that. My question is two fold
1) is all that holds the flywheel on to the main shaft are these set screws?
2) I can't seem to get the belt tight enough. Would the belt tension have something to do with the pulley sliding off? Should I try to get a longer bolt? (i have a bolt on the freshwater pump that pushes against the bell housing)
Any suggestions? Tonight we got in by my friend hold a hammer against the pulley not allowing it to slide off.
Thanks guys
1) is all that holds the flywheel on to the main shaft are these set screws?
2) I can't seem to get the belt tight enough. Would the belt tension have something to do with the pulley sliding off? Should I try to get a longer bolt? (i have a bolt on the freshwater pump that pushes against the bell housing)
Any suggestions? Tonight we got in by my friend hold a hammer against the pulley not allowing it to slide off.
Thanks guys
Comment