I just removed the ignitor round magnetic core "on my delco distributor in
order to lube the flywheel weight mechanism underneath the plate
When I went to reinstall the core I discovered that it could slide on in 2 different positions 180 degrees apart.
I Checked my installation instructions and it only mentions fully
seating it below the rotor around 1/2 inch and nothing about
which position it belongs in of the 2 180 degrees apart
Does it matter which of the 2 positions it is installed in?
Thanks Art
order to lube the flywheel weight mechanism underneath the plate
When I went to reinstall the core I discovered that it could slide on in 2 different positions 180 degrees apart.
I Checked my installation instructions and it only mentions fully
seating it below the rotor around 1/2 inch and nothing about
which position it belongs in of the 2 180 degrees apart
Does it matter which of the 2 positions it is installed in?
Thanks Art
Comment