I am trying to adjust forward properly. I can get good detent. However when I pull throttle up and hold it in place the engine sounds better and seems to perform smoother. I plan to go one more notch on the adjusting collar. Also, I installed a new clutch cable and it keeps slipping out of the bracket that holds it in place on the engine. The bottom bolt on the bracket is very difficult to access. Does anyone have any tips on how to tighten it down so the cable will not slip. Finally, is the cable suppose to be in the bracket itself or the metal "lip" at the end where the "cable" exits go in the bracket.
Forward Adjust & Clutch Cable
Collapse
X
-
Hi Brian.
Originally posted by brianm132 View PostHowever when I pull throttle up and hold it in place the engine sounds better and seems to perform smoother.
Originally posted by brianm132 View PostFinally, is the cable suppose to be in the bracket itself or the metal "lip" at the end where the "cable" exits go in the bracket.
Mark S
-
-
Brian,
You should resist the temptation to pull up and hold pressure on your shifting lever at all costs! This places a continual side-load on the ball bearing on your operating cone (which most of us motor-heads call a "throw-out" bearing). Throw-out bearings are not designed for continuous duty but only for the brief amount of time they are used in actually engaging or disengaging the forward clutch latching mechanism (the forward detent). If an operating cone fails, it requires major disassembly of the engine to replace and access issues sometimes require engine removal to do so.
Don
Comment
-
-
Thanks Don. You may recall, that is what I had to do over the winter. I replaced the reversing gear which required removing the engine. Without that bit of advice I probably would be doing it again. With that being said should I adjust the forward detent or just be satisfied with where it is now? It clicks into gear fine.Brian C. Morrison
REKOFA
Universal Sailing Club
Baltimore, MD
Comment
-
Comment