Just a flat washer.
I've thought of a stud, but it's the same problem, only a different thread count. Getting a tap handle in there is going to be tricky. Then you have the problem of lining the pump up with the studs while at the same time getting the slot on the pump shaft to engage with the bar inside the accessory drive.
There are various solutions involved JBWeld or similar, but it seems a bit oily back there.
I've thought of a stud, but it's the same problem, only a different thread count. Getting a tap handle in there is going to be tricky. Then you have the problem of lining the pump up with the studs while at the same time getting the slot on the pump shaft to engage with the bar inside the accessory drive.
There are various solutions involved JBWeld or similar, but it seems a bit oily back there.
Comment