I recently received 3 keys with a new output coupling from Moyer Marine. Two are shorter and one is longer. Does anyone know what the correct length should be?
output coupling key length?
Collapse
X
-
Output couplng key
Mark,
We've seen factory installations with key lengths between 1 1/8" and 1 1/2". The key should never be more than 1 1/2" since this is the fore and aft dimension of the output coupling and the key should not extend past the coupling when installing the coupling on the tail shaft. Don
-
-
Output coupling key
Mark,
I need to back peddle on one point I made in my previous post, which was that keys up to 1.5" are OK to use between output couplings and tail shafts. This is NOT the case. The tab on the tab washer takes up some of the space in the keyway, and (more importantly) there is a small ramp in the bottom of the keyway in the tail shaft just forward of the bevel spacer which which also takes up some of the total available length of the keyway. Bottom line, the two short keys that measure just over 1" are perfectly OK to use. The longer key is NOT. Sorry for the slip up! Don
Comment
-
Comment