Idler shaft puller
Hi Greg,
Hopefully you didn't tighten the inside part of the puller too tightly, in which case you should be able to wrap some protective material around the spindle and hold it gently with a pair of vise grips. Thin cardboard, like a piece of file folder material should work. I always held the spindle on the smaller end that goes into the block so that if I ended up with any dings I could take a small file and dress that area up a bit. Don
Hi Greg,
Hopefully you didn't tighten the inside part of the puller too tightly, in which case you should be able to wrap some protective material around the spindle and hold it gently with a pair of vise grips. Thin cardboard, like a piece of file folder material should work. I always held the spindle on the smaller end that goes into the block so that if I ended up with any dings I could take a small file and dress that area up a bit. Don
Comment