Hello! I've just switched from a mechanical fuel pump to an electrical one (works like a charm). However, I want to install a oil pressure safety switch where it is recommended to do so (where the arrow points on the picture: https://www.moyermarineforum.com/for...1&d=1660252652 ).
The problem is that this screw is completely jammed! I've tried adding wd-40, but it won't turn one bit. So l, I thought I had two options: drill the screw or install the switch somewhere else.
Since I really don't want to take the chance of damaging the hole's thread, Im looking for another place to install it. Is this possible at all?
Thanks a lot for your inputs!
Julien
The problem is that this screw is completely jammed! I've tried adding wd-40, but it won't turn one bit. So l, I thought I had two options: drill the screw or install the switch somewhere else.
Since I really don't want to take the chance of damaging the hole's thread, Im looking for another place to install it. Is this possible at all?
Thanks a lot for your inputs!
Julien
Comment