Hello,
I'm replacing the impeller on my Oberdorfer 202 pump and as you can see from the picture, the new impeller is sticking out a bit. Is this normal or do I just not have the shaft seated all the way in? (I removed the whole shaft, not just the impeller, so I could get at it with the snap ring pliers more easily.)
Also, do I have the blades oriented correctly? As I'm facing the pump housing it rotates counterclockwise, right? I'm trying to visualize the blades doing there job but I'm not convinced I've got this right.
I'm replacing the impeller on my Oberdorfer 202 pump and as you can see from the picture, the new impeller is sticking out a bit. Is this normal or do I just not have the shaft seated all the way in? (I removed the whole shaft, not just the impeller, so I could get at it with the snap ring pliers more easily.)
Also, do I have the blades oriented correctly? As I'm facing the pump housing it rotates counterclockwise, right? I'm trying to visualize the blades doing there job but I'm not convinced I've got this right.
Comment