I'm in the process of putting my A4 back together after an extended stay at the machine shop, and have most of it assembled. But have ran into an issue.
When I went to put the fuel pump push rod back in, I remember it sliding right out, it gets jammed up in the bushing just as it should be passing through on the camshaft side. I was able to tap it all the way in with a screw driver but then had to use vice grips to get it back out. Obviously something happened while it was getting machined and the bushing should get reamed out. With the engine mostly assembled is there anyway to clean out the bushing without disassembling the engine?
When I went to put the fuel pump push rod back in, I remember it sliding right out, it gets jammed up in the bushing just as it should be passing through on the camshaft side. I was able to tap it all the way in with a screw driver but then had to use vice grips to get it back out. Obviously something happened while it was getting machined and the bushing should get reamed out. With the engine mostly assembled is there anyway to clean out the bushing without disassembling the engine?
Comment