Things are going from bad to worse. First I had the short in my control panel, then the compression issue in two cylinder and now I found water in the oil.
I drained the pan a couple of times and based on a lot of comments decided to work on removing the cylinder head to check and probably replace the gaskets.
I was fortunate that the nuts and in some case the studs came out quite easily but what is the best way to remove the head? I have tried to use a chisel but no luck. I don't want to hit it too hard to cause damage to the head.
Any comment is greatly appreciated.
heinz
I drained the pan a couple of times and based on a lot of comments decided to work on removing the cylinder head to check and probably replace the gaskets.
I was fortunate that the nuts and in some case the studs came out quite easily but what is the best way to remove the head? I have tried to use a chisel but no luck. I don't want to hit it too hard to cause damage to the head.
Any comment is greatly appreciated.
heinz
Comment