My 28’ Sabre has an atomic 4, motor starts right up ( when choked), and i can ‘unchoke’ after a couple minutes. Will run at idle speed all day, and in gear cruises me around 2 knots at slow speed - ran three or four miles yesterday at this speed, no problems. But as soon as I try to give a little more gas, motor stalls. UNLESS I pull the choke again, then it will stay running at high rpms. I did some searches, but couldn’t find the likely culprits. Any ideas? Thanks.
Boat is new to me, I drained the old fuel and replaced with fresh, and replaced spin on water separating filter. May have an oil pressure problem too, or it may be the gauge, sender, or wiring.
Boat is new to me, I drained the old fuel and replaced with fresh, and replaced spin on water separating filter. May have an oil pressure problem too, or it may be the gauge, sender, or wiring.
Comment