Since neither I nor anyone on the forum have been able to find the cause of my problem I am looking for advice on a work around.
Problem: After running for random amounts of time, at random rpms, on random loads, the engine (Atomic 4) will die and will not restart. Switching over to another coil immediately solves the problem. The problem existed before and since the installation of electronic ignition. All the coils used pass the higher amp test and are oil filled. After cooling down the coil that died will work again. The leads are all new.
Workaround: I want to be able to mount 2 coils and as required switch back and forth between them. Obviously switching the positive and negative leads is easy but what type of switch is used for the center lead? Also are there length restrictions on the various wires as this will determine where the dwitch will be located.
Problem: After running for random amounts of time, at random rpms, on random loads, the engine (Atomic 4) will die and will not restart. Switching over to another coil immediately solves the problem. The problem existed before and since the installation of electronic ignition. All the coils used pass the higher amp test and are oil filled. After cooling down the coil that died will work again. The leads are all new.
Workaround: I want to be able to mount 2 coils and as required switch back and forth between them. Obviously switching the positive and negative leads is easy but what type of switch is used for the center lead? Also are there length restrictions on the various wires as this will determine where the dwitch will be located.
Comment