Don,
I've attached a picture of what I believe to be my oil pressure safety switch which must have been installed when my new fuel pump was installed. As you have written, there is a wire from the positive side of the coil to the blue fuse and into the assumed switch. My problem is that the two other wires at my fingertips were left unconnected. I guess the thicker black is a ground and perhaps the other is neutral but what do I do with them? DO I connect both to the engine block?
Thanks a lot.
Lisa ("forcenine")
Cat 27 "Knot His"
I've attached a picture of what I believe to be my oil pressure safety switch which must have been installed when my new fuel pump was installed. As you have written, there is a wire from the positive side of the coil to the blue fuse and into the assumed switch. My problem is that the two other wires at my fingertips were left unconnected. I guess the thicker black is a ground and perhaps the other is neutral but what do I do with them? DO I connect both to the engine block?
Thanks a lot.
Lisa ("forcenine")
Cat 27 "Knot His"
Comment