I am currently installing a FWC system on my A4. I was back flushing the block and placed a hose on the manifold exit hole and blocked the forward manifold input port expecting flushing of the block from the internal port. I understand that the manifold is cooled by two ports the external one at the forward end of the manifold and the internal one between the block and manifold. There was no flow from the block at the open ports. Am I mistaken and that all manifold cooling comes from the forward input port?
Before I started the conversion I noticed that the water line form the rear manifold was cold. I also noted that forward spark plug (all new plugs) was carbon-ed up. When I opened the side plate for the cold water in side and the thermostat housing I found 7 impeller tips in the engine. Three of them were lodged in the thermostat and were blocking it open. That explains why it was running cold.
Is is likely that I have a blocked engine/manifold port?
Thank you,
Mart
Before I started the conversion I noticed that the water line form the rear manifold was cold. I also noted that forward spark plug (all new plugs) was carbon-ed up. When I opened the side plate for the cold water in side and the thermostat housing I found 7 impeller tips in the engine. Three of them were lodged in the thermostat and were blocking it open. That explains why it was running cold.
Is is likely that I have a blocked engine/manifold port?
Thank you,
Mart
Comment