Engine always runs without fault. Ran for 3 minutes and shut down. Not fuel issue. NO SPARK. Replaced EI module, new Moyer Coil, new distributor cap, new rotor button. EI has proper gap, test light across coil +/- light turns on and off. Connect spark plug to coil wire and spark at plug. Connect coil to distributor and check spark at plug - NO SPARK. I have jumped coil from battery and I am jumping starter to control at engine. New Coil wire but no impact.
So what am i missing???? Why coil output but nothing from the distributor output to any of the plugs
Checked advance weights and they are very clean, springs seem effective when I take a screw driver and spread the weights they pop right back. No gunk, rust or stuff around the weights. Nothing binding them.
I am at a total loss on what the next step is.
So what am i missing???? Why coil output but nothing from the distributor output to any of the plugs
Checked advance weights and they are very clean, springs seem effective when I take a screw driver and spread the weights they pop right back. No gunk, rust or stuff around the weights. Nothing binding them.
I am at a total loss on what the next step is.
Comment