Hello Afourians,
when I started my engine yesterday, I noticed exhaust down below. Upon further inspection I found salt water escaping through a hole in the exhaust right above the water injection. The pipe easily split in half when I started working on removing the hoses.
Any tips as far as what to replace it with? Stainless steel or bronze? I'm looking for the least expensive, yet sufficiently good quality solution.
Should this section be wrapped with high heat tape?
Thank you!
when I started my engine yesterday, I noticed exhaust down below. Upon further inspection I found salt water escaping through a hole in the exhaust right above the water injection. The pipe easily split in half when I started working on removing the hoses.
Any tips as far as what to replace it with? Stainless steel or bronze? I'm looking for the least expensive, yet sufficiently good quality solution.
Should this section be wrapped with high heat tape?
Thank you!
Comment