Hi A's.
I had a rusted pipe break, and am trying to replace the end section of piping, past the elbow section. My problem was the Home Depot and Lowes only had enough black iron piping to replace with 1" sections, they didn't have 1.25".
I found an 1.25" to 1" converter, and bought the supplies to replace the end of the system with 1" piping.
Before I do this, I am hoping you could advise if this will have negative effects?
Too much pressure in the exhaust system due to smaller fittings?
Piping in red is the area I'm replacing, at a total length of about 12 inches
Thanks!
I had a rusted pipe break, and am trying to replace the end section of piping, past the elbow section. My problem was the Home Depot and Lowes only had enough black iron piping to replace with 1" sections, they didn't have 1.25".
I found an 1.25" to 1" converter, and bought the supplies to replace the end of the system with 1" piping.
Before I do this, I am hoping you could advise if this will have negative effects?
Too much pressure in the exhaust system due to smaller fittings?
Piping in red is the area I'm replacing, at a total length of about 12 inches
Thanks!
Comment