I'm in agreement with Tom that at minimum a carb cleaning is needed.
Are you sure that the CHOKE is closing when you try to start?
You need to remove the Flame Arrester to actually see if it's closed.
Also, have you tried adjusting the fuel mixture?
An over lean mixture could cause a hard or no start.
Lastly, on that Main Passage Plug, there should be a washer (see pic)
IF that's missing, you would have found your air leak I'd think.
Are you sure that the CHOKE is closing when you try to start?
You need to remove the Flame Arrester to actually see if it's closed.
Also, have you tried adjusting the fuel mixture?
An over lean mixture could cause a hard or no start.
Lastly, on that Main Passage Plug, there should be a washer (see pic)
IF that's missing, you would have found your air leak I'd think.
Comment