Went to the boat today and did some engine work. Took a few pics to get some feedback on. The distributor has a cap with two screws (no clips), does that mean something? The distributor looks like EE, right? The rotor is a little pitted, but the inside of the cap looks good. Fairly new 8mm wires. Coil looks good, and has 4.1 ohms across it.
I'm working on giving it a tune up and a rewire. The engine was running but hard to start. I plan on checking the timing after the rewire and tune up. I tried to take the plate under the rotor off, but it was lifting the center rod up too. So I left it in place till I could get more info of what is going on.
I am open to any comments, questions, or advice about what you see in the pics or what I've said. Also the tube above the flame arrester is missing. ?
I'm working on giving it a tune up and a rewire. The engine was running but hard to start. I plan on checking the timing after the rewire and tune up. I tried to take the plate under the rotor off, but it was lifting the center rod up too. So I left it in place till I could get more info of what is going on.
I am open to any comments, questions, or advice about what you see in the pics or what I've said. Also the tube above the flame arrester is missing. ?
Comment