#1
IP: 172.58.47.37
|
|||
|
|||
Engine passage question
Hi all. I'm attempting to refurb a CL A4 purchase. One task is removing a good amount of rust debris in the block. Per a4 manual, ive been able to excavate and open passages via coat hanger/welding rods. One passage has me puzzled, however. Its in the flywheel end, starboard side of the motor under the starter. might anyone know where this passage should lead? Seems lower than the cylinder cooland area, but doesn't seem oil related either. Pic attached. Thanks much for any assist.
Last edited by WAcat30; 11-20-2020 at 12:58 PM. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Engine starts, runs a few seconds and quits | Neuse River Sailor | Troubleshooting | 24 | 08-11-2017 06:57 PM |
2010 MoM rebuilt engine suddenly won't turn over | denesszabo | Troubleshooting | 13 | 12-01-2015 10:34 PM |
RWC Engine temperature question | Ajax | Cooling System | 27 | 11-19-2015 01:13 PM |
Fuel-Related Engine Shutdowns | Don Moyer | Fuel System | 32 | 02-18-2011 04:36 PM |
Bent push rods in new engine with 10 hours on it | Frank | Troubleshooting | 3 | 09-14-2010 02:23 AM |