#1
IP: 216.54.24.2
|
||||
|
||||
Items Wanted for A4 rebuild
Hoping there individuals out there for the following small items I require to finish a late model A4 I am building as a backup. Understand that I just placed a heavy order with MM recently and need to conserve on this second build where possible. PM me with your prices?
Thanks, Aaron Late Model A4 Parts Needed: 1. Pawl/finger with pin from drive coupling 2. Thermostat housing 3. Water jacket cover plate 4. Temperature sensor/transducer 5. Complete set of piston rings (standard size) 6. Camshaft bearings (standard size) 7. Single intake and exhaust valve plus keepers |
#2
IP: 68.60.179.71
|
||||
|
||||
I will check my spares bins to see about valves and keepers. I don't know what shape they are in, but I might have a couple taken out of a block that was scrapped. I will PM if I find any usable.
In the meantime, I am assuming you are looking for new piston rings and bearings? Second, have you thought about a second hand reversing gear (complete) rather than a single finger? Finally, on this forum we LOVE the story. Tell us about your motor : )
__________________
Mike |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP...leaking Carb. after rebuild. | sproption | Fuel System | 13 | 05-13-2013 06:29 PM |
To Rebuild or Not To Rebuild (That is the Question) | jkenan | General Interest | 13 | 02-07-2011 03:29 PM |
Proud Rebuild | mike7a10 | General Interest | 4 | 04-21-2010 05:38 PM |
Rebuild Tips | hd78half | Overhaul | 4 | 05-12-2007 09:24 AM |