I'm about ready to set my engine back on the beds but have a question.
I cannot for the life of me remember where the copper tube - just in front of the carb and behind the flywheel goes. I've circled it in the Moyer photo attached and it appears capped off. What is this for? Can I cap it?
I have an MMI manifold if that matters
I do recall on my previous engine I teed in the fuel pump switch here, but this motor has it installed at the rear.
Second picture is a short view of what i am installing...I got bored so color...
Thanks All
I cannot for the life of me remember where the copper tube - just in front of the carb and behind the flywheel goes. I've circled it in the Moyer photo attached and it appears capped off. What is this for? Can I cap it?
I have an MMI manifold if that matters
I do recall on my previous engine I teed in the fuel pump switch here, but this motor has it installed at the rear.
Second picture is a short view of what i am installing...I got bored so color...
Thanks All
Comment