#12
IP: 155.186.122.195
|
|||
|
|||
The emulsion well is in the middle of the float bowl. The fuel from the main jet feeds fuel into it and air is fed into it via vacuum and metered by the main air (corrector) jet. The chamber has a sealing surface that must be sealed by the bowl gasket. This seal is a must for good carb performance. This feature will not leak fuel into the throat though. Look to the float and or setting for that.
Dave Neptune |
The Following User Says Thank You to Dave Neptune For This Useful Post: | ||
TimBSmith (10-16-2021) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Burnt Wire in harness from Control Panel to A4 | doogymon | Troubleshooting | 13 | 08-07-2020 04:56 PM |
Question about coils/spark plugs | gtwiggpharmd | Ignition System | 6 | 07-17-2017 03:21 PM |
Throttle-Shift Question | systemek | General Interest | 16 | 04-17-2012 08:58 PM |
RPM at Idle Question | jwilson1515 | Troubleshooting | 19 | 01-26-2012 11:36 AM |
Gasoline smell | High Hopes | General Interest | 81 | 11-23-2010 10:01 PM |