#1
IP: 24.36.18.93
|
|||
|
|||
Valve Adjustment
Don,
I found in one of your posts a valve adjusting procedure stating that proper clearence for the valve / tappet as .010 for the intake & .012 for the exhaust. In the technical data section of a service manual by Universal I find stated clearences "cold" to be .008 & .010. After all this work I would like to get this right. Can you shed some light? Thanks for your help again. Jim |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Broken Valve Spring | redwitch | Troubleshooting | 9 | 09-18-2020 11:03 PM |
Carburetor float adjustment | COB | Fuel System | 9 | 08-08-2012 11:16 AM |
fuel pump adjustment? | altair | Fuel System | 2 | 10-26-2010 07:55 PM |
Broken valve stem stuck in the valve guide | Unregistered | General Maintenance | 1 | 11-19-2005 08:26 AM |
Valve adjustment | Banyan Day | General Maintenance | 1 | 02-14-2005 07:53 PM |