#1
IP: 98.203.141.195
|
|||
|
|||
Xintex monoxide detector mounting
Hey everyone,
So am addressing some safety concerns. Now that I have engine running reasonably well I want to install a monoxide detector. To my knowledge there was never one there before but PO did have an old Xintex gas fume detector. Where do you usually mount these ? It said to not put it near stove, but i figue i want it reasonably close to the engine. http://www.hodgesmarine.com/XINTEX-C...r.htm?click=19 Also this model is 12 dc wiring. Do you direct mount it to the battery like a bilge pump ? I am mostly concerned with these fumes when I am at the boat. I do not live/sleep aboard so am wondering if maybe i should just hook it to DC panel and have it "on" when I am running the engine and the few times I sleep on boat in summer. Thoughts ? Thanks |
#2
IP: 74.78.27.200
|
||||
|
||||
Where you breathe and sleep
The ABYC A-24 standard suggests in the living and sleeping spaces, which is intuitive. If they are far enough apart, or isolated by ventilation, you may want more than one. A risk may be not your engine, but the one idling in a nearby slip!
I would put it on a panel circuit and leave it on when you're on the boat. Always.
__________________
Jeff S/V Bunny Planet 1971 Bristol 29 #169 |
#3
IP: 199.173.224.31
|
||||
|
||||
My CO detector is at my chart table. You do NOT want it next to the engine. You want it closer to the people on the boat. My wife and son frequently are sound asleep underway and I do not like people sleeping below under power without a CO alarm. I may add one in the V-berth to cover both ends of the boat.
Quote:
|
#4
IP: 4.53.154.230
|
|||
|
|||
Thanks guys for the responses. I guess chart table area sounds about as good as any, and maybe another in vberth later on.
PS - my thought behind placing it "close" to the engine was that I am often working on that engine ( sometimes when its running ) and I would like to know if I am getting a bad dose of CO when fiddling with it. Can I ask your reasoning for having it away from engine compartment ? Thanks |
#5
IP: 74.78.27.200
|
||||
|
||||
Choices
The CO detector should be where people are and ventilation is restricted (E.G. most anywhere below deck).
Generally, your engine compartment is going to be closed. And if you smell exhaust when working, you already have a big problem you should be working on. But a properly functioning exhaust should not emit CO inside the boat. Very often CO comes back onboard by reverse ventilation, not from the engine compartment, but from the tailpipe! A following wind while motoring is a good example.... Idling at the dock.... Someone else idling at the dock nearby.... If the CO detector is inside the engine compartment, it will react too slowly, or not at all (!) to an increase within the cabin. The USCG has some good PDF information about CO online....
__________________
Jeff S/V Bunny Planet 1971 Bristol 29 #169 |
#6
IP: 99.124.190.130
|
||||
|
||||
Not sure why you want a 12V unit wired into the panel. I prefer a 'home' unit with it's own internal battery. They last a long time!
|
#7
IP: 198.11.8.218
|
||||
|
||||
The unit originally posted was UL 2034 Listed for Marine use
__________________
Jeff S/V Bunny Planet 1971 Bristol 29 #169 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carbon Monoxide Problems - ugh!! | Kurt | Exhaust System | 12 | 08-26-2009 10:38 AM |
Blowby and Carbon Monoxide? | Kurt | General Interest | 5 | 06-13-2009 12:17 PM |