MMI is pleased to announce the following new control panel enclosure products. These enclosures are an ideal choice for installations where a minimal protrusion is desired and the instrument panel may be subjected to frequent exposure to weather and/or spray. Constructed of sturdy ABS plastic, the enclosures also feature a clear acrylic hinged spray shield. The bottom edge of the recess is sloped to facilitate drainage.
When installing the panel, use a sealant which is compatible with ABS plastic.
A Velcro closure at the bottom center of the panel secures the cover.
Four mounting holes are predrilled in the corners of the exterior flange and four #8 Philips flat-headed stainless mounting screws are included. No other holes are predrilled. Gauges not included; scale is approximate.
Depth of the panel is 1-1/4 inches. If you're contemplating installing a key, check this dimension.
Control Panel Enclosure 9-3/8 inches (click here)
This enclosure is capable of accommodating (4) two-inch gauges or equivalent.
Control Panel Enclosure 12 inches (click here)
This enclosure is capable of accommodating (6) two-inch gauges or equivalent.
A picture of the larger unit is shown below:
When installing the panel, use a sealant which is compatible with ABS plastic.
A Velcro closure at the bottom center of the panel secures the cover.
Four mounting holes are predrilled in the corners of the exterior flange and four #8 Philips flat-headed stainless mounting screws are included. No other holes are predrilled. Gauges not included; scale is approximate.
Depth of the panel is 1-1/4 inches. If you're contemplating installing a key, check this dimension.
Control Panel Enclosure 9-3/8 inches (click here)
This enclosure is capable of accommodating (4) two-inch gauges or equivalent.
Control Panel Enclosure 12 inches (click here)
This enclosure is capable of accommodating (6) two-inch gauges or equivalent.
A picture of the larger unit is shown below:
Comment