Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Overhaul

Thread Tools Display Modes
  #1   IP:
Old 10-03-2022, 04:39 PM
Dr Chill Dr Chill is offline
Join Date: Sep 2022
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
hole behind camshaft sprocket

Folks, I'm rebuilding an atomic four that was stored for several years after being partially assembled. I've been following the manual. I have the pistons and crankshaft in, the crankcase oil pan in. As I'm putting the camshaft in, I notice that there's a hole behind the sprocket. It doesn't appear to have been tapped, and it has evidence of being painted. Is there something that needs to go into that hole, or is it there to allow oil to pass from the block over to the transmission housing?
Attached Images
Reply With Quote
  #2   IP:
Old 10-04-2022, 10:23 AM
Dave Neptune Dave Neptune is online now
Afourian MVP, Professor Emeritus
Join Date: Jan 2007
Location: Grove, Oklahoma
Posts: 4,978
Thanks: 699
Thanked 1,234 Times in 808 Posts
There are some oil galley plugs throughout the engine, they are threaded and use NPT plugs. There are also galleys that return and move unpressurized oil around to keep the trans oiled and oil flowing back to the pump. If not threaded it is probably the latter.

I no longer have a MMI Manual so I can't look it up to be sure. It looks to me to be an oil source for the gears, just not sure.

Dave Neptune
Reply With Quote
  #3   IP:
Old 10-04-2022, 08:44 PM
Dr Chill Dr Chill is offline
Join Date: Sep 2022
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Thanks Dave! That's what it looks like to me, too.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Camshaft During Engine Overhaul. Refurbish? Replace? Repent? Retreat? Launchpad McQ Overhaul 24 11-12-2018 03:16 PM
Port coil bracket mounting bolt threaded hole missing, well kinda' Elizabeth_B29 General Interest 13 03-28-2014 02:21 AM
early 80's A4's block deck blister/bubble @ frwd stud hole! 3rd Newport Introductions 1 12-21-2012 01:06 PM
Covering the hole ILikeRust General Interest 5 03-28-2011 08:18 AM

All times are GMT -4. The time now is 11:52 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2023, vBulletin Solutions, Inc.

Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2023 Moyer Marine Inc.

All Rights Reserved