|
View Poll Results: Are you capable of drilling and tapping a hole in an engine component. | |||
Absolutely. | 38 | 52.05% | |
Probably. | 25 | 34.25% | |
Probably not. | 8 | 10.96% | |
Absolutely not. | 2 | 2.74% | |
Voters: 73. You may not vote on this poll |
|
Thread Tools | Display Modes |
#1
IP: 38.102.16.112
|
||||
|
||||
Drilling and tapping a hole
Help me settle another breakfast table bet with Don.
The question is this: Laying aside the issue of access, would you consider yourself capable of drilling and tapping a hole in an engine component and willing to undertake the task for some reasonable benefit? Bill Last edited by Administrator; 06-16-2011 at 08:57 AM. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Defective Head/Manifold Studs | Don Moyer | General Interest | 2 | 09-29-2021 07:43 PM |
What is behind this hole? | rpowers | General Maintenance | 7 | 02-25-2011 05:40 AM |