#1
IP: 73.176.217.12
|
|||
|
|||
A4 ""Early Model" Rebuilt 4 Sale
I have a early model crated/skid A4 for sale that I have had in heated storage for 30yrs. I bought it thinking that one day I might need it in my 1966 Morgan 34 which I have had for 47 yrs. with help from this forum the original engine is still running strong and I am losing my storage space. I bought it from an elderly gentleman who had what mechanics call "short block" rebuild but his son repowered his boat with a diesel. He had in storage for 8yrs as well after bench testing. Periodically I would shoot some oil in the cylinders and hand rotate the crankshaft - all works well.
The crate is 2ft x 3ft x 28 in. high, engine is complete with monted carb, prestolite/points distributor, mechanical fuel pump, water pump, coil, wire harness, hoses, new [then] marine generator with mechanical regulator etc. #UJ74922 mid 1960's vintage, painted red, came out of a Sorverel 29, bolt pattern is 11 1/2 in wide x 15 7/16 in long using 3/8 in lag bolts, price $1000 w/o shipping. Located in near south side Chicago boat yard. Thx, Sam |
#2
IP: 32.220.250.10
|
||||
|
||||
Price doesn't seem out of line.
For truck shipping, you want to be able to get a pallet lift under the crate. Perhaps a couple of lengths of 4x4 screwed on through the bottom of the crate? I shipped an A4 a few years back, and used a full size pallet (happened to have one). Built an engine bed on the pallet, then built the box. Didn't want it tipping over! |
#3
IP: 73.176.217.12
|
|||
|
|||
Thx for your thoughts. That exactly what the PO did - fabricated a solid test bed, had 2 x 4 's on bottom to accommodate forklift blades and built solid 1/2-inch plywood box/lid around engine and base. I didn't see any need to change and that was way it was stored.
After a little thinking since I don't have direct usage experience with the engine, I'll medicate risk by returning purchase price if buyer has a mechanical issue. |
#4
IP: 38.70.61.129
|
||||
|
||||
it shouldn't be hard to run a compression check and block pressure check if you want to avoid sending it out and getting it back
__________________
Joe Della Barba Coquina C&C 35 MK I Maryland USA |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A-4 For Sale, 50 hours on rebuilt. $3200 | hpweisse | For Sale - Engines and Engine Parts | 11 | 08-31-2020 08:01 AM |
two A4's for sale. One rebuilt, the other running | MikeInMaine | For Sale - Engines and Engine Parts | 15 | 01-31-2016 04:05 PM |
Rebuilt A4 for sale in NJ | Val V | For Sale - Engines and Engine Parts | 15 | 01-16-2015 09:38 AM |
Rebuilt A4 for sale in FL | wpatstone | For Sale - Engines and Engine Parts | 0 | 04-18-2011 10:11 PM |
Rebuilt A4 for Sale!!! | john | For Sale - Engines and Engine Parts | 1 | 07-25-2010 02:19 PM |