Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Specialty Tools

Reply
 
Thread Tools Display Modes
  #1   IP: 24.152.132.140
Old 08-14-2020, 11:29 AM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 9,493
Thanks: 190
Thanked 2,033 Times in 1,342 Posts
Impeller puller

For those who have horrible access to their water pump, have you seen the MMI impeller puller tool? It is designed to be a single hand operation without sight on the pump and from first hand experience I can tell you it works exactly as described.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Reply With Quote
The Following User Says Thank You to ndutton For This Useful Post:
GregH (08-14-2020)
  #2   IP: 207.32.171.10
Old 04-17-2022, 03:08 PM
capnward's Avatar
capnward capnward is offline
Afourian MVP
 
Join Date: Aug 2012
Location: Deer Harbor WA
Posts: 313
Thanks: 30
Thanked 135 Times in 101 Posts
I too, have bad access to the raw water pump. It is a Moyer flange pump. FWC. Recently I tried to buy the impeller tool, but they are sold out. So, I removed the pump. I still was unable to remove the impeller. It was really stuck on the shaft. So, I drove the shaft partway out until the impeller was almost free, then I could pull it out with pliers. After driving the shaft back in, I installed the new impeller, using never-seize on the shaft. I worried about damaging the seals, but apparently they are ok. The end of the shaft had made a divot on the inside of the back plate, from the shaft being driven in to far, although the flange on the shaft should have prevented that. I think this created heat that fried the impeller to the shaft. It all works now.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
New impeller won't prime. Ajax Cooling System 26 06-13-2016 02:05 PM
Replacment impeller for Oberdorfer not making the grade Baltimore Sailor Cooling System 17 06-28-2013 12:57 PM
Changing the impeller Unregistered Cooling System 10 12-03-2009 03:43 PM
Impeller Woes patsfan Cooling System 1 08-06-2006 07:59 AM


All times are GMT -4. The time now is 08:33 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2022, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2022 Moyer Marine Inc.

All Rights Reserved