#1
IP: 104.34.16.57
|
|||
|
|||
FWC and rebuilt engine install advice sought.
I am currently in the process of installing a freshly overhauled A4 and have a FWC heat exchanger with all the hardware. My request is, does someone have a diagram for plumbing?(Ill try and get a brand and photo) I understand the fundamentals of said system, but dont want to make a setup up mistake. My boat is a small 14 foot launch and you could say I have a "blank canvas" in regards to installation and setup.
In addition, I am also putting in new wiring but trying to use the original electrical switches, instruments and gauges . Lastly, I must say I really enjoy this forum and gather a lot of good intel for this classic engine. Thanks in advance and have a great day! Doug A. |
#2
IP: 100.40.58.241
|
|||
|
|||
Hello Doug.
You may already have this, but in case you don't, here are the MMI instructions for installing the Moyer FWC system, with diagrams: https://moyermarine.com/wp-content/u...FWK_01_264.pdf Hope this helps. Jack. |
#3
IP: 98.155.50.7
|
||||
|
||||
Welcome to the forum.
It your FWC system based on a mechanical pump or electric?
__________________
Thanks, Ron Portland, OR |
#4
IP: 104.34.16.57
|
|||
|
|||
Thanks
Yes it is a mechanical setup. It indeed seems to be a MMI fresh water cooling system.(but there seems to be no markings) I will go through the parts tomorrow and take inventory. Thank you for the link, it is most helpful.
Regards....Doug A. |
#5
IP: 138.207.177.95
|
||||
|
||||
Big question - does it have the heat exchanger you see in the Moyer listing or the one some A4s come with that mount on the engine?
|
|
|