|
#1
IP: 74.79.251.149
10-03-2022, 03:39 PM
|
|||
|
|||
|
hole behind camshaft sprocket
Folks, I'm rebuilding an atomic four that was stored for several years after being partially assembled. I've been following the manual. I have the pistons and crankshaft in, the crankcase oil pan in. As I'm putting the camshaft in, I notice that there's a hole behind the sprocket. It doesn't appear to have been tapped, and it has evidence of being painted. Is there something that needs to go into that hole, or is it there to allow oil to pass from the block over to the transmission housing?
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camshaft During Engine Overhaul. Refurbish? Replace? Repent? Retreat? | Launchpad McQ | Overhaul | 24 | 11-12-2018 02:16 PM |
| Port coil bracket mounting bolt threaded hole missing, well kinda' | Elizabeth_B29 | General Interest | 13 | 03-28-2014 01:21 AM |
| early 80's A4's block deck blister/bubble @ frwd stud hole! | 3rd Newport | Introductions | 1 | 12-21-2012 12:06 PM |
| Covering the hole | ILikeRust | General Interest | 5 | 03-28-2011 07:18 AM |
Threaded Mode