#1
IP: 68.161.242.65
|
||||
|
||||
Hole in Manifold
I have a very small hole in the manifold that was dicovered while flushing the cooling system. Any other choices to fix this other than relacing the manifold?
|
#2
IP: 68.34.11.142
|
||||
|
||||
pictures??
|
#3
IP: 71.190.155.199
|
||||
|
||||
A picture won't show much. It's in the middle, on the lower part right above the bolt head. I have no problem replacing the manifold, I was just wondering if there was a temporary fix so I could move my boat.
|
#4
IP: 66.108.48.122
|
||||
|
||||
JB Weld epoxy
could be used as a temporary fix.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Manifold studs at different angles! | duncan59 | General Maintenance | 8 | 12-18-2007 10:33 PM |
Manifold Cooling Passages Completely Blocked | Xestenz | Exhaust System | 3 | 03-16-2007 07:57 PM |
New Manifold Leak, Overheat | Unregistered-Catalina 30 | Troubleshooting | 11 | 06-26-2006 07:58 AM |
Re-installing exhaust manifold | 1973 Ericson | Exhaust System | 2 | 11-29-2005 09:31 AM |