|
#1
IP: 73.223.157.68
03-08-2021, 11:13 PM
|
|||
|
|||
|
How To Remove Rusted Distributor Flywheel Mechanism
Hi - I have a late model engine and pulled the distributor system for a good cleaning. I've disassembled most of it -- I've gotten the stem (that holds the felt), springs, and first level of the flywheel mechanism off.
I can't seem to get the lowest portion off the shaft. Am I making a mistake in trying to get it fully disassembled, is it just rusted on, or am I missing a step in removing it? Thank for any advice you may be able to share. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removal of Prop Coupling - To Remove Engine | ajgaines | Overhaul | 10 | 09-03-2019 11:34 AM |
| Engine very hard to start after cleaning distributor advance mechanism | TomG | Troubleshooting | 10 | 02-11-2012 04:56 PM |
| Removing the engine from your boat | Don Moyer | General Interest | 13 | 06-27-2008 11:06 AM |
| Removing the engine from your boat | Don Moyer | Ranger | 7 | 12-12-2005 12:24 PM |
| Hoses hard to remove | HOTFLASH | Cooling System | 0 | 11-11-2005 01:22 PM |
Threaded Mode