Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Introductions

Thread Tools Display Modes
  #26   IP:
Old 01-20-2022, 06:17 PM
Jim_G Jim_G is offline
Senior Member
Join Date: Jan 2022
Location: Mission Viejo, CA
Posts: 15
Thanks: 0
Thanked 3 Times in 3 Posts
Just a quick note to follow up on results with Carburetor clean up. Disassembled and general clean up and snaked jets and passages with small wire from twist tie. Everything looked pretty good still from 2018 rebuild. Also adjusted floats and set idle mixture and adjustable main jet to recommended MMI settings. Changed out polishing and water separating filters and new fuel lines. Reinstalled today and started on second try and ran pretty rough for a few minutes but then evened out and seems to run good. Just slight tweaks to idle mixture and main jet.

New alternator charging at 14.5 amps at 1800 rpms and volt meter showing same.

Thanks to everyone on this site, appreciate the help.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Is the atomic 4 reliable? Long read. Mo General Interest 14 09-29-2021 07:32 PM
Taking long passages with gas engine amizerin General Interest 22 08-20-2020 09:49 PM
Looking for an A4 mechanic in Long Beach, CA heyflyboy Good Guys 1 06-26-2017 07:59 PM

All times are GMT -4. The time now is 05:29 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2022, vBulletin Solutions, Inc.

Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2022 Moyer Marine Inc.

All Rights Reserved