Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > General Maintenance

Reply
 
Thread Tools Display Modes
  #1   IP: 162.219.70.239
Old 06-15-2022, 06:05 PM
Peter's Avatar
Peter Peter is offline
Afourian MVP
 
Join Date: Jul 2016
Location: Nova Scotia, Canada
Posts: 297
Thanks: 162
Thanked 140 Times in 101 Posts
Oil pressure question

Hi all,

The Maintenance Manual describes in winter layup that one should warm up the engine nicely, drain the oil, and replace with a quart of MMO. And this also “facilitates recommissioning in the spring when you only need to add enough new oil to bring the level to the full mark.”

I have followed this procedure for the last two seasons and my oil pressure has been on the lower side compared to when I ran with no MMO in the oil.

Previously I would get 60 lbs on start up and 40 when warmed up. Now I get 40 lbs on startup and it sags to 30 when warmed up and down to 20 at idle.

Do you folks change the oil in spring to remove the MMO?

Will the MMO evaporate as time goes on and I will then top up with regular oil?

The exhaust smells lovely (MMO in fuel too) but not as nice as castor oil that I used to smell at the race track.

Engine started beautifully this spring and runs like a top. Am I being a Nervous Nellie?

Appreciate your wise advice!

Peter
Reply With Quote
  #2   IP: 138.207.177.95
Old 06-16-2022, 07:47 AM
joe_db's Avatar
joe_db joe_db is online now
Afourian MVP
 
Join Date: May 2009
Posts: 4,474
Thanks: 49
Thanked 1,026 Times in 721 Posts
I have never done anything like that. I just change the oil in the fall and use that oil until the next fall or 100 hours, whichever comes first.
Reply With Quote
  #3   IP: 162.245.50.230
Old 06-16-2022, 09:44 AM
Dave Neptune Dave Neptune is online now
Afourian MVP, Professor Emeritus
 
Join Date: Jan 2007
Location: Grove, Oklahoma
Posts: 5,035
Thanks: 711
Thanked 1,289 Times in 839 Posts
Question

Peter, when you changed the oil did you always use the same "weight and grade" of oil? And did you always have the same percentage of MMO in the oil upon your start up?

The numbers are not bad at all, at least nothing to worry about.

Frankly I do not and have not used MMO in my oil ever. The MMO is a hi-detergent type of oil and was good 75 years ago when there was nothing available in "detergent oils" like today. There are far better lubricants today for top oils in the fuel too. It is good for soaking rings if there stuck which seldom happens with todays "modern" and superior detergent oils unless there was water encroachment. IMHO

Dave Neptune
Reply With Quote
  #4   IP: 162.219.70.239
Old 06-16-2022, 09:57 AM
Peter's Avatar
Peter Peter is offline
Afourian MVP
 
Join Date: Jul 2016
Location: Nova Scotia, Canada
Posts: 297
Thanks: 162
Thanked 140 Times in 101 Posts
Dave,

My notes are not careful enough to answer that question I am afraid.

Maybe just for fun I will change the oil mid season and see if the pressure pops up.

Thanks!

Peter
Reply With Quote
  #5   IP: 138.207.177.95
Old 06-16-2022, 10:46 AM
joe_db's Avatar
joe_db joe_db is online now
Afourian MVP
 
Join Date: May 2009
Posts: 4,474
Thanks: 49
Thanked 1,026 Times in 721 Posts
Quote:
Originally Posted by Dave Neptune View Post
Peter, when you changed the oil did you always use the same "weight and grade" of oil? And did you always have the same percentage of MMO in the oil upon your start up?

The numbers are not bad at all, at least nothing to worry about.

Frankly I do not and have not used MMO in my oil ever. The MMO is a hi-detergent type of oil and was good 75 years ago when there was nothing available in "detergent oils" like today. There are far better lubricants today for top oils in the fuel too. It is good for soaking rings if there stuck which seldom happens with todays "modern" and superior detergent oils unless there was water encroachment. IMHO

Dave Neptune
I too have never put MMO in the oil. It is much thinner than the regular lube oil, I have no doubt it would lower the pressure.
Reply With Quote
The Following 4 Users Say Thank You to joe_db For This Useful Post:
Dave Neptune (06-16-2022), Sam (06-16-2022), sastanley (06-21-2022), thatch (06-16-2022)
  #6   IP: 67.184.216.83
Old 06-16-2022, 03:58 PM
Sam Sam is offline
Afourian MVP
 
Join Date: Apr 2010
Posts: 322
Thanks: 490
Thanked 140 Times in 109 Posts
I too have never added MMO to oil, fuel yes - oil no. I have had for the last 45yrs a 1966 early model that has never needed rebuilding. It is a short season in Chicago and I usually clock about 25 to 30hrs a year engine time with the longest run being about 6 hrs each way to and from yard ...a lot of shorter runs entering/leaving harbor. I was an engineer and not a chemist but recommend and do change oil mid season and just prior to haul out for winter layup. I use any quality 4qts 10w-30 or 30 with some STP added at spring launch. My layman's understanding from an old mechanic friend is that besides some viscosity thickening it contains extra zinc which aids in improving lubricity and resists corrosion. Oil pressure at start up is about 45psi and settles down to about 35psi and about 25psi at idle. To some [and manual] this may sound a little wasteful but for about an extra $15 and half hr of time I like the idea of clean oil in a non filtered engine. Just my thoughts- hope this helps.
Reply With Quote
  #7   IP: 73.35.200.244
Old 06-16-2022, 05:28 PM
Boat Boat is offline
Senior Member
 
Join Date: Aug 2014
Location: Kirkland, WA
Posts: 172
Thanks: 1
Thanked 14 Times in 13 Posts
echoing the same as guys above. my climate is pretty mellow here in the PNW compared to some. just an oil change for me in the spring before the season. every 100hrs after that. No MMO in fuel or oil.
__________________
'69 Newport 30 MKI Hull #20
Reply With Quote
  #8   IP: 207.32.171.10
Old 06-18-2022, 01:24 AM
capnward's Avatar
capnward capnward is offline
Afourian MVP
 
Join Date: Aug 2012
Location: Deer Harbor WA
Posts: 335
Thanks: 41
Thanked 147 Times in 107 Posts
I am one of the eccentrics who puts MMO in fuel and oil. I have been doing this for 20 years and well over 3,000 hours since the last rebuild. I understand that it thins the oil and thus makes the oil pressure lower. I often ignore the oil pressure, but it goes from 40 to under 30 psi as it warms up. I change oil every 50 hours, as recommended by the Moyer manual. That is usually 3 or 4 times a year. IMO it is much more important to add MMO to the fuel. I use 2 oz. for every five gallons. I read somewhere in this forum that the old engineers who worked for Universal testing these engines swore by using MMO in the fuel. I may stop putting it in the oil as an experiment. When I do add it, it's 8 oz. added to 3.5 quarts of 'diesel-type' 10w40. which is 7%. I have never needed to open the valve cover. The engine purrs once warmed up, although when I started her up in the spring this year there was a tapping noise that went away after a few minutes. I had not run the engine for five months and put some MMO in the cylinders to soak for a few days before starting.
Reply With Quote
The Following User Says Thank You to capnward For This Useful Post:
TimBSmith (06-18-2022)
  #9   IP: 174.202.103.39
Old 06-18-2022, 07:56 AM
Indy Indy is offline
Senior Member
 
Join Date: Oct 2014
Posts: 33
Thanks: 14
Thanked 3 Times in 3 Posts
I just use straight 30 weight, and change in the fall before haul out. At the risk of taking this off topic, is there any concern that with a shared sump and a wet clutch, it may be advantageous to use something like motorcycle oil?
Reply With Quote
  #10   IP: 69.250.111.245
Old 06-21-2022, 03:27 PM
sastanley's Avatar
sastanley sastanley is online now
Afourian MVP
 
Join Date: Sep 2008
Location: Solomons, MD
Posts: 7,016
Thanks: 1,134
Thanked 600 Times in 442 Posts
Indy, I run 5w-40 synthetic "diesel truck" oil in mine.

~55 PSI at startup and settles in about 37-39 PSI when warm. I also have the Indigo oil filter with adjustable oil pressure attachment too, so I've been able to dial mine wherever I want it.
__________________
-Shawn
"Holiday" - '89 Alura 35 #109
"Twice Around" - '77 C-30, #511 with original A-4 & MMI manifold - SOLD! (no longer a two boat owner!!)
http://www.moyermarine.com/forums/signaturepics/sigpic3231_6.gif
Reply With Quote
  #11   IP: 165.225.20.162
Old 06-21-2022, 04:23 PM
Surcouf's Avatar
Surcouf Surcouf is offline
Afourian MVP, Professor Emeritus
 
Join Date: May 2018
Posts: 361
Thanks: 328
Thanked 163 Times in 123 Posts
Quote:
Originally Posted by Peter View Post
... Now I get 40 lbs on startup and it sags to 30 when warmed up and down to 20 at idle.

...
Forum users statistics
https://www.moyermarineforum.com/for...ead.php?t=3333
__________________
Surcouf
A nostalgic PO - Previously "Almost There" - Catalina 27 (1979)
Reply With Quote
The Following User Says Thank You to Surcouf For This Useful Post:
Peter (06-21-2022)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
oil pressure question billsalton General Interest 5 07-03-2011 08:23 AM
Oil Pressure Adjustment Jesse Delanoy General Maintenance 59 07-24-2010 09:14 PM
Information about information and oil pressure issues Don Moyer Announcements 0 04-14-2009 08:30 AM
Oil Pressure / Rear oil seal - Next step Mark Harrington Drive Train / Propellers 6 11-24-2008 08:51 AM
Carburetor Internal Pressure Regulation Don Moyer Fuel System 2 04-12-2005 09:30 AM


All times are GMT -4. The time now is 08:33 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved