|
#1
IP: 107.0.6.242
01-27-2016, 10:59 PM
|
||||
|
||||
|
Strange Carb
Can anyone ID this carb? It is stamped "Zenith" and "made in USA. All cast iron, #10074.
Last edited by hanleyclifford; 07-13-2016 at 08:24 PM. 
|
|
#2
IP: 71.118.13.238
01-28-2016, 04:09 PM
|
|||
|
|||
|
Hanley, looks like one of the old original cars on the A-4 from Zenith as it is cast iron.
Take a look inside for the venturi ID and see if it has the internal scavenge tube to determine if it is a marine carb. Very interested in the venture diameter for sure. Oh and thanx for sending the prop back. Dave Neptune 
|
|
#3
IP: 24.138.22.213
01-28-2016, 04:59 PM
|
||||
|
||||
|
I was doing some looking and the number does correspond to a replacement float for a zenith updraft antique carb....used on Case Tractors and other machinery. IH, and other equipment sometimes used the "same" or very similar carbs. From what I read the same carb, back in the day, might have been on a few different engines made by different manufactures... An eye opener for me but I couldn't hunt it down definitely.
__________________
Mo "Odyssey" 1976 C&C 30 MKI The pessimist complains about the wind. The optimist expects it to change. The realist adjusts the sails. ...Sir William Arthur Ward.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| oops ,, idle hands cause much trouble | BadaBing | Fuel System | 28 | 01-20-2016 03:40 PM |
| carb flush? | HalcyonS | Fuel System | 29 | 02-17-2014 10:18 AM |
| Carb For Palmer P60 - Same as Atomic 4? | bpowdrell | Fuel System | 3 | 08-29-2012 08:58 AM |
| 5 bolt gasket on a 4 bolt carb? | sastanley | Fuel System | 5 | 12-03-2008 01:22 PM |
| Carb Identity | ScottLynds | Fuel System | 2 | 06-16-2005 11:20 AM |
Linear Mode
