#26
IP: 107.0.6.242
|
||||
|
||||
Quote:
|
#27
IP: 68.56.139.11
|
||||
|
||||
Hanley, then I think you did fine with yours.
|
#28
IP: 107.0.6.243
|
||||
|
||||
Odd tools
You never know when some useless piece of hardware store junk will become useful. A 6' bath curtain rod constructed of the cheapest, lightest but straightest brass (probably by child labor in Bangladesh) has become my first line engine alignment rod. The cutless is new and the distance from it to the engine is about half the length of the shower rod which is a 1" perfect fit in the cutless. By runing it in and observing where it lands on the engine output coupling, crude initial positioning of the "dog" can be made.
Last edited by hanleyclifford; 07-13-2016 at 08:32 PM. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cutlass bearing | Crash | Drive Train / Propellers | 17 | 10-19-2011 12:54 AM |
Cutlass Bearing Play | Steveb | Drive Train / Propellers | 2 | 05-18-2011 07:10 AM |
When does a leak start to matter? | Administrator | General Interest | 19 | 12-08-2009 09:46 AM |
Cutlass bearing and Stuffing box | m_galligan | Drive Train / Propellers | 4 | 11-30-2009 05:20 PM |
Bad cutlass chatter? | High Hopes | Troubleshooting | 5 | 05-20-2009 10:28 AM |