#1
IP: 64.32.196.134
|
|||
|
|||
Oil Pressure Sending Unit Nipple
Reading the safety considerations on page 1-2 of the MMI A4 Svc. & Overhaul manual, it seems to me preemptively replacing the oil pressure sending unit nipple on a 32-year-old (assumed) engine would be an easy enough thing to do. Is that the point of Product No. - BRSS_05_431, Brass nipple 1/8" x 1 1/2" on this page?
Thanks, Jim |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oil Pressure / Rear oil seal - Next step | Mark Harrington | Drive Train / Propellers | 6 | 11-24-2008 08:51 AM |
Temperature Gauge Sending Unit | Jesse Delanoy | Cooling System | 6 | 10-25-2008 07:41 AM |
Oil Pressure Gauge Maxed Out | PeterMulhern | Troubleshooting | 2 | 07-07-2008 10:04 AM |
Oil Pressure Guage or Sending Unit | N29sailor | General Maintenance | 0 | 10-14-2007 09:27 PM |
Carburetor Internal Pressure Regulation | Don Moyer | Fuel System | 2 | 04-12-2005 09:30 AM |