|
#1
IP: 174.198.4.58
05-24-2023, 09:44 AM
|
|||
|
|||
|
EWDS - Raw Water Sensor
Hi everyone,
This question is specifically for folks who have installed the EWDS. I purchased mine toward the end of last season apparently just prior to MMI discontinuing it. I installed the pieces over the winter but have a concern with the raw water sensor. The instructions call for it to be placed before the water pump inlet. When I place it here I get very little to no water flow, to the point that I have concerns with the engine overheating. So I removed it. Has anyone installed it after the water pump and had better success? Additional info, I changed the impeller on my wayer pump a year ago, and I get plenty of flow when the sensor is not installed. I also verified the flow direction is correct on the sensor itself. Any other pieces I'm missing? Thanks! 
|
|
#2
IP: 76.176.224.167
05-24-2023, 11:28 AM
|
||||
|
||||
|
Just sent you a Private Message.
__________________
Neil 1977 Catalina 30 San Pedro, California prior boats 1987 Westsail 32, 1970 Catalina 22 Had my hands in a few others
|
 |
| Tags |
| EWDS, Raw water, temperature |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Winterizing A4 and General Boat Preparation | Mo | General Maintenance | 85 | 11-05-2021 06:26 AM |
| atomic 4 - 6 months of salt water - lost cause? | taylor | Overhaul | 35 | 01-30-2021 10:32 PM |
| Flow Sensor Maintenance | ndutton | Cooling System | 21 | 11-17-2020 12:38 PM |
| Head Removal rabbit hole | Hiker_00 | Overhaul | 49 | 12-04-2012 11:33 PM |
| acid flush of Fresh water cooled engine | skhorleb | Cooling System | 1 | 01-16-2007 10:07 AM |
Linear Mode
